Cabling & Bracingin Wildwood, MO
Cabling and bracing in Wildwood for the big oaks and hickories standing near the house on wooded acreage.
5.0 average from 59+ Google reviews
Support for the trees nearest the house
On a Wildwood property the trees deep in the woods can fail on their own schedule, but the big oaks and hickories near the house cannot. When one has a heavy limb over the roof or a fork that has started to open, a steel cable installed high between the stems, or a rod through a cracked fork, lets you keep the tree. On acreage, saving a tree is also far cheaper than removing one that no machine can reach.
Baylor climbs and inspects the fork and the wood around it first. Sound wood gets a cable installed high and a light pruning to take weight off the long side. Decay at the fork means a cable will not hold, and we say so. Everything is done by climbing because there is rarely room for equipment near these trees, and the cable is checked again in a few years.
Backyard tree removal. Drag the handle to compare.
How we handle it
- 1.
Assess the union
We climb or inspect the fork up close, check for cracks, decay, and included bark, and tell you straight whether support makes sense.
- 2.
Choose the system
Dynamic cable, static cable, brace rods, or a combination, matched to the tree's condition and how much it needs to move.
- 3.
Install high and tight
Hardware goes in at roughly two-thirds of the way up the stems, anchored properly so it strengthens the tree instead of wounding it.
- 4.
Prune and schedule the re-check
We reduce weight on the supported limbs, then set a plan to inspect the system every few years and after major storms.
What sets the price
A support system in Wildwood is quoted after we climb and inspect the tree. The price depends on:
Size of the tree
A big oak needs heavier hardware and a longer climb than a young maple.
How many stems to support
Two stems need one cable; three or four need more.
Cable or rod
A cable high in the tree is the common fix; a threaded rod through a cracked fork is added when the split has already started.
Pruning at the same time
Taking weight off the long side usually goes with the cable and is quoted together.
Access
Everything is done by climbing, so a tree in a tight spot takes a little longer.
The full picture of this service is on our cabling & bracing page, and everything we do locally is on the Wildwood tree service page.
Working in Wildwood
Wildwood is about thirty-five minutes from our shop at 211 Hughes Ln in St. Charles, so we often combine a cabling job with trimming or clearing on the same visit to make the trip count.
Cabling & Bracing nearby
What neighbors say about this work
5.0 average from 59+ Google reviews
Heather Hanson
“Baylor and the boys did an awesome job removing a dead tree from my front yard and deadwooding a few others. They were fast and efficient and the clean up was thorough. Most importantly though, they were honest and didn't try to sell me a bunch of BS that I didn't need. Their quote was so much more reasonable than a few others I got as well. I will definitely be using these guys from here on out for any tree needs! Thanks Baylor!”
Alicia Thompson
“The customer service is impeccable. Responded to my initial inquiry in a timely manner. Reasonable priced. Great service. Great communication. Highly Recommend!”
Mick Schlueter
“BC was very knowledgeable in his field. He executed extreme care when dropping limbs around power lines. Would highly recommend. A+ rating.”
Common questions in Wildwood
Is cabling cheaper than removing the tree in Wildwood?
Almost always. A cable and a careful pruning on a healthy Wildwood tree is a fraction of the cost of taking the tree down and grinding the stump, and you keep the shade. The exception is a tree with decay at the fork, where a cable will not hold and removal is the honest answer.
How do I know if my tree needs a cable?
The usual signs are a tight, narrow fork where two or three trunks meet, a crack or a seam of bark running down into that fork, or a long, heavy limb reaching over the house. If you see any of those, have the tree looked at before the next storm rather than after it.
Will the cable be visible from the ground?
Barely. The cable is installed high in the tree, about two thirds of the way up to where the limbs spread, and once the tree leafs out it is hard to spot. A bracing rod sits inside the fork and is not visible at all.
Do I need a permit for cabling in Wildwood?
No. Installing a support system on your own tree does not need a permit in Wildwood, and in cities with tree preservation rules, keeping the tree with a cable avoids the approval a removal would need.
Worried about a fork in a Wildwood tree?
Get a free, honest assessment before the next storm decides for you. If the tree can be saved, we will save it.